Features
- Colour matched to drain pipe
- Release station at different heights
- Removeable locking pins
- Instant drop down
- Manufactured from aluminium
- Drill bits, fixing kits, bolts and plugs included
- Any combination of set sizes can be accommodated
Specification
Hover over image to en-large specification diagram
Installation video
Downloads
Installation
After unpacking, sections of ladder can be joined together for longer lengths.
Additional Rungs need to be added where two sections are joined.
Measure 400mm from the floor to bottom of ladder.
Measure the overall height of the ladder from your mark.
Drill a hole 60mm deep and fix an alignment bolt 50mm from the top of the ladder.
Support the ladder on the alignment bolt, this will allow the ladder to self plumb.
Punch the position of each wall bracket hole. Brackets can be moved on ladder if required.
Remove ladder and drill pilot holes 80mm deep with 8mm drill provided.
Enlarge holes with 12mm drill provided.
Fit wall plugs into holes.
Rehang ladder on alignment bolt.
Bolt ladder to wall.
Use spacers behind bracket on uneven walls.
Check drop down operation of the ladder.
Every release section is locked with a lock pin, which is pulled in an emergency.
The pins are out of reach of unauthorised access from the ground and are shaped specifically to avoid tampering.